NON STERILE MILLIPAK 40

General description

Millipak^® membrane products are designed for routine filtration applications in the laboratory. Millipak^® filters are best-in-class proven products used in lab water purification systems to provide particulate-free and bacteria-free water to benefit the stringent requirements of scientific applications.

Application

Purified water filtered through a Millipak^® 40 filter can be used for any laboratory work where water free of bacteria and/or particulates is needed.

Features and Benefits

• Millipak^® membrane filters are made with Durapore^® PVDF membranes, providing high flow rates and throughputs, low extractable and broad chemical compatibility.
• The membrane is supported by a rigid plastic disc with channels that ensures high water flow and resistance to pressure variations without the risk of membrane rupture.
• Millipak^® membrane filters use a unique, clean stacked disc design, allowing minimal hold-up volume and particle shedding.
• Connect to the outlet of the water delivery point, such as the PODs of Milli-Q^® water purification systems.
• The protective bell protects against intrusion of airborne bacteria contamination during dispensing.
• Care-free maintenance: the filter is easily fitted and replaced.

Other Notes

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Directions for Use

• Organism Retention: Microorganisms
• Mode of Action: Filtering
• Application: General laboratory analysis
• Intended Use: Water purification
• Instructions for Use: This item provides water filtered through 0.22 μm sterilizing-grade membranes and is a device that meets requirements under FIFRA. Refer to system equipment user guide section "Using the System" (available on USB key in the system box).
• Storage Statement: Store in dry location
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations.

Preparation Note

This product was manufactured with a Durapore^® membrane which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6).

Analysis Note

Bacterial Retention
Samples were quantitatively retentive of a minimum Brevundimonas diminuta challenge concentration of 1 x 10⁷ CFU/cm² using ASTM^® F838 methodology.

Gravimetric Extractables: after 24 hours in water at controlled room temperature

Legal Information

ASTM is a registered trademark of American Society for Testing and Materials

Durapore is a registered trademark of Merck KGaA, Darmstadt, Germany

MILLIPAK is a registered trademark of Merck KGaA, Darmstadt, Germany

Milli-Q is a registered trademark of Merck KGaA, Darmstadt, Germany