Microscope condensers

Borosil&reg Liebig Condensers have an interchangeable inner and outer joint with a drip tip. This simple design has a thin wall for the inner tube, facilitating efficient heat transfer with a low cooling capacity.

Used for continuous extraction of analytes from a solid into an organic solvent WHEATON Connection eliminates the need for hooks, springs and clamps common to standard ground joint designs As the flask containing the solvent is heated, vapors rise in

AS24-2 Aluminum alloy rotor kit with lid

Type: Zemike Phase Contrast Numerical Aperture: Abbe 1.25 For Series Models: 1210&#39s, 1220&#39s, 1230&#39s, 1286ECM

Type: Brightfield Numerical Aperture: Abbe 1.25 For Series Models: 1210&#39s, 1220&#39s, 1230&#39s

Liebig condensers are used to cool and condense hot vapor as part of a distilling apparatus. This condenser has a straight inner tube that the condensing vapor passes through, and a larger outer jacket that cooling water passes through.

Liebig condensers are used to cool and condense hot vapor as part of a distilling apparatus. This condenser has a straight inner tube that the condensing vapor passes through, and a larger outer jacket that cooling water passes through.

With Standard Taper Joints Complete with Allihn condenser with joint at bottom, Soxhlet extraction tube with top and bottom joint and flat-bottom flask Available in small, medium and large capacities Small Extractor with 125 mL flask (4406E10, E16,

Condenser 400mm

These PYREX&reg condensers have a high surface area per unit length of the 300mm long jacket with a 24/40 Standard Taper outer joint at the top and a plain drip tip at the bottom. They are primarily used in distillation assemblies.

These PYREX&reg condensers have a high surface area per unit length of the 200mm long jacket with a 19/38 Standard Taper outer joint at the top and a plain drip tip at the bottom. They are primarily used in distillation assemblies Condenser

Jumbo Soxhlet extraction apparatus equipped with a Duran flange at the top of the extractor. Flange is formed with a groove in the flat portion of the mating surface to accept a PTFE covered silicone o-ring to permit grease free assembly.